Bambu Station L

3D printing · Project

Bambu Station L

The frame version of the cabinet for Bambu printers comes with open sides, and its drawers have a sheet-metal front that sits 15 mm behind the frame. Printed side panels and fronts turn it into a closed cabinet – flush, screwed on, no drilling.

PETGDesigned in FusionSTEP · STL · 3MFFree on MakerWorld
Bambu Station L with printed side panels and drawer fronts

Two kits

Side panels

Fill the recess on each side (520 × 450 mm) and sit flush in it. Four parts per side, the same files for left and right.

Drawer fronts

Close the whole opening (414 × 460 mm) and end flush with the frame. Four handle styles to choose from.

No drilling

The side panels hang on four M5 screws, the fronts clamp to the existing slots of the metal drawer front.

Side panel with the WorldGate logo

Side panels

518 × 448 mm, 9 mm thick: a 2.4 mm outer skin with a rib grid behind it. To fit the print bed, each side is split into four quarters (about 265 × 230 mm each, so H2 series or larger). The seams are held by printed diamond pins and M3 screws in heat-set inserts.

Open drawer with the inside of the side panel behind it

From the inside

Inside you can see the rib grid and the screwed seams. Each side needs 12 M3×10 screws with heat-set inserts and four M5 screws to mount it to the frame.

Drawer fronts with bar handles and logo

Drawer fronts

411 mm wide, 15 mm deep, 218.5 mm high at the top and 236.5 mm at the bottom, with a 2 mm gap between them and 1.5 mm clearance to the frame. Each front is a left and a right half; the largest part is about 212 × 237 mm and fits a 256 mm bed.

Drawer front from the inside with ribs and clamp plates

Mounting

Two M3 screws per side go from the inside through a printed clamp plate and the slot of the metal front into heat-set inserts in the front. The slots leave room to align the gaps.

Four handles

All four styles share the same mounting. The bar handle is printed and in use; the other three are designed but not printed yet.

Bar handle

Bar handle

Closed front, the printed bar is screwed on from behind.

Low slot

Low slot

A finger slot just above the metal front. The stiffest style, nothing sticks out.

Centre arc

Centre arc

The grip is the earth arc from the WorldGate emblem.

Top grip

Top grip

A finger notch in the top edge of the front.

Key facts

  • PETG, 0.2 mm layers, outer face down, no supports
  • Side panels: H2 series or larger; drawer fronts: also 256 mm beds
  • M3×10 screws (DIN 912) with heat-set inserts, hole Ø 4.1 mm
  • Side panels also need four M5 screws per side
  • STEP files included for your own changes
And the logo?